SiPass Auxiliary Objects Commands

The section presents a description of the SiPass auxiliary objects (inputs/outputs) and the related control commands available from the Desigo CC management station. These inputs/outputs can be used to connect optional external devices such as buzzers, horn, lights, and elevators. For UL/ULC Access Control compliance information, see Notice for UL/ULC Norms Compliance.

SiPass Auxiliary Input Commands

The following table shows and explains the available input commands.

Door Command	Description
Disable	Permanently excludes the input from the system. This command overrides the programmed enable/disable schedule that may be defined in the SiPass configuration.
Enable	Permanently includes the input in the system. This command overrides the programmed enable/disable schedule that may be defined in the SiPass configuration.
Cancel PA	Cancels the Permanent Action (PA) of manual Enable or Disable. This command does not change the current input status, but removes the permanent effect of the latest Enable/Disable command. This allows a subsequent programmed action to complete successfully.
Return to AC	Returns to Access Control (AC) the input control with immediate effect. This command cancels the latest Enable/Disable command and results in the input status being updated as necessary to reflect the current programmed schedule.

SiPass Auxiliary Output Commands

The following table shows and explains the available output commands.

Door Command	Description
Secure	Permanently sets the relay output to the secure state (default condition, which can be configured as normally open or normally closed). This command overrides the programmed secure/unsecure schedule that may be defined in the SiPass configuration.
Unsecure	Permanently sets the relay output to the unsecure state (as opposite to the configured secure state). This command overrides the programmed secure/unsecure schedule that may be defined in the SiPass configuration.
Allow Access	Temporarily sets the relay output to the unsecure state to allow an access. The activation delay is programmed in the SiPass configuration.
Allow Access > Cancel PA	Cancels the Permanent Action (PA) of manual Secure or Unsecure. This command does not change the current output status, but removes the permanent effect of the latest Secure/Unsecure command. This allows a subsequent programmed action to complete successfully.
Allow Access > Return to AC	Returns to Access Control (AC) the output control with immediate effect. This command cancels the latest Secure/Unsecure command and results in the output status being updated as necessary to reflect the current programmed schedule.
Allow Access > Single Pulse	Set the relay output to the unsecure state for 3 sec, and then back to secure.
Allow Access > Toggle	Inverts the status of the relay output.
Lock	Sets the relay output to the secure state for a specified a period of time (hhh:mm:ss).
Unlock	Sets the relay output to the unsecure state for a specified a period of time (hhh:mm:ss).
Fast Pulse	Sends out a series of high-frequency pulses (1-sec period) for a specified period of time (hhh:mm:ss).
Slow Pulse	Sends out a series of low-frequency pulses (2-sec period) for a specified period of time (hhh:mm:ss).